BASIC INSPECTION [AW6AX-EL]

id0503j6800300

STEP	INSPECTION		ACTION
1	•  Measure the battery voltage. •  Is the battery voltage 10.0—14.0 V?	Yes	Go to the next step.
		No	Replace or recharge the battery. (See BATTERY RECHARGING [MZI-3.7].)
2	•  Inspect the TCM related harnesses, connectors and fuses. •  Are they normal?	Yes	Go to the next step.
		No	Repair or replace any malfunctioning parts according to the inspection result.
3	•  Warm up the engine to normal operating temperature. •  Retrieve DTC using the M-MDS. •  Is there any DTC present?	Yes	Record Freeze Frame Data and perform appropriate DTC troubleshooting procedures.
		No	Go to the next step.
4	•  Perform the road test. •  Is the ATX operating normally?	Yes	Go to the next step.
		No	Repair or replace any malfunctioning parts according to the inspection result.
5	•  Perform the time lag test. •  Is the ATX operating normally?	Yes	Go to the next step.
		No	Repair or replace any malfunctioning parts according to the inspection result.
6	•  Perform the stall test. •  Is the stall speed within the specified?	Yes	Go to the next step.
		No	Repair or replace any malfunctioning parts according to the inspection result.
7	•  Perform the line pressure test. •  Is the line pressure within the specified?	Yes	Perform the symptom troubleshooting and follow the procedures.
		No	Repair or replace any malfunctioning parts according to the inspection result.
8	•  Inspect following part or signal related PIDs using the M-MDS. ―  APP sensor ―  TSS ―  VSS ―  TFT sensor ―  TR switch ―  M range switch ―  Up switch ―  Down switch ―  Brake switch ―  Engine speed •  Are they normal?	Yes	Perform the symptom troubleshooting and follow the procedures.
		No	Repair or replace any malfunctioning parts according to the inspection result.