DTC B1330 [BCM]

id0902f5838100

DTC B1330

Passenger door ajar circuit short to ground
DETECTION CONDITION
Short to GND in wiring harness between BCM and front door switch (passenger-side)
POSSIBLE CAUSE
•  Short to GND in wiring harness between BCM terminal 6M and front door switch (passenger-side) terminal A
•  Front door switch malfunction
•  BCM malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION
1
INSPECT FRONT DOOR SWITCH (PASSENGER-SIDE) CONNECTOR
•  Turn the ignition switch off.
•  Disconnect the front door switch (passenger-side) connector.
•  Inspect the front door switch (passenger-side) connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion).
•  Is there any malfunction?
Yes
Repair or replace the terminal, then go to Step 5.
No
Go to the next step.
2
INSPECT BCM CONNECTOR
•  Disconnect the BCM connector.
•  Inspect the BCM connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion).
•  Is there any malfunction?
Yes
Repair or replace the terminal, then go to Step 5.
No
Go to the next step.
3
INSPECT FRONT DOOR SWITCH (PASSENGER-SIDE) SIGNAL CIRCUIT FOR SHORT TO GND
•  Inspect for continuity between BCM terminal 6M (wiring harness-side) and body GND.
•  Is there continuity?
Yes
Repair or replace the wiring harness for a possible short to GND, then go to Step 5.
No
Go to the next step.
4
INSPECT FRONT DOOR SWITCH (PASSENGER-SIDE)
•  Inspect the front door switch (passenger-side).
•  Is there any malfunction?
Yes
Replace the front door switch (passenger-side), then go to the next step.
(See DOOR SWITCH REMOVAL/INSTALLATION.)
No
Go to the next step.
5
VERIFY TROUBLESHOOTING COMPLETED
•  Make sure to reconnect all disconnected connectors.
•  Clear the DTC from the BCM memory using the M-MDS.
•  Perform the BCM DTC inspection.
•  Is the same DTC present?
Yes
Replace the BCM.
(See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION.)
No
DTC troubleshooting completed.