DTC B1317 [AUTO LIGHT/WIPER CONTROL MODULE]
id0902j1830900
DTC B1317 |
Battery voltage high |
---|---|
DETECTION CONDITION
|
Input voltage from the battery is excessively high
|
POSSIBLE CAUSE
|
• Battery malfunction
• Generator malfunction
• Auto light/wiper control module malfunction
|
Diagnostic procedure
STEP |
INSPECTION |
ACTION |
|
---|---|---|---|
1
|
INSPECT DTC FROM PCM
• Connect the M-MDS to the DLC-2.
• Are any DTCs from the PCM displayed?
|
Yes
|
Perform DTC inspection.
(See DTC TABLE [MZI-3.7].)
Go to the next step.
|
No
|
Go to the next step.
|
||
2
|
VERIFY TROUBLESHOOTING COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the auto light/wiper control module memory using the M-MDS.
• Turn the ignition switch to LOCK position then ON position.
• Is the same DTC present?
|
Yes
|
Replace the auto light/wiper control module.
|
No
|
DTC troubleshooting completed.
|