POWER WINDOW SYSTEM OPERATION

• The window opens/closes according to the down (push) or up (pull) operation of the power window main switches and the power window subswitches.

• The front windows automatically moves to a fully-opened or closed position when the power window main switches or the power window subswitche is operated two times, either down (push) or up (pull).

• If the following operations have been performed, initial setting is reset, and auto up/down and two-step down operation are disabled. Therefore, performing initial setting is necessary.

• The driver-side power window initialization procedure can be performed only using the power window main switch.

• The passenger-side power window initialization procedure can be performed using the power window main switch and subswitch (Passenger side).

• If the power window initialization procedure is not completed, the power window (Driver and passenger sides) does not operate automatically. Each power window can be operated only in manual operation.

• If any object is pinched in the window during auto-close operation, the window automatically opens approx. 200 mm {7.9 in}.

• If a switch is lightly pushed (manual open operation) when the window is completely closed, the window lowers a set distance. (Initial setting is approx. 30 mm {1.2 in}.)

• If the manual open operation is performed with the two-step down function enabled, the window will always stop momentarily. (This is not a malfunction.)

• The set distance the window goes down can be changed. (Within a range of approx. 20-100 mm {0.79-3.9 in}.)

• The two-step down function can be disabled. (Initial setting is enabled)

• If the operation of the auto open/close, manual close or window obstruction is detected during two-step down function operation, these other operations are given priority.

• Does not function during IG OFF Timer operation.

• Allows operation of the driver's power window for approx. 40 s after the ignition switch has been turned from the ACC to the LOCK position.However, when the front door is opened/closed during IG OFF timer, the function stops.

• The power window system is switched to fail-safe mode to prevent a malfunction when the P/W CM detects a malfunction in the pulse signal (Hall IC).

Detection condition	IG switch ON	IG switch OFF	Recovery items
Hall effect switch 1 (for jam-safe and window position detection) operation malfunction • During up/down movement, Hall effect switch 2 pulse detected but Hall effect switch 1 pulse not detected	Automatic operation prohibited	Automatic and manual operation prohibited	During up movement, pulse signals for Hall effect switches 1 and 2 detected normally, and fully closed position return/non-return ranges redetected
Hall effect switch 2 (for window movement direction detection) operation malfunction • During up/down movement, Hall effect switch 1 pulse detected but Hall effect switch 2 pulse not detected
Pulse signal malfunction detected (Inversion of input signals of or large phase deviation between, Hall effect switch 1 and 2.) • During up/down movement, difference detected between the direction signals from Hall effect switches 1 and 2, and actual direction
Non-return range downturn malfunction • During up movement, the signal input from Hall effect switch 1 higher than the position stored in the P/W main switch
Hall effect switches 1 and 2 operation malfunction • Hall effect switches 1 and 2 pulse signal not detected after down movement initiated from the fully closed position