WINDSHIELD WIPER MOTOR INSPECTION

id091900801100

1.  Disconnect the windshield wiper motor connector.

2.  Connect battery positive voltage to windshield wiper motor terminal A or B, and ground to terminal D, then verify that the windshield wipers operate as shown in the table.

am8rrw00001163

•  If the windshield wipers do not operate as indicated in the table, replace the windshield wiper motor.

Terminal connected to battery positive voltage	Operation condition
A	LO
B	HI

3.  Disconnect battery positive voltage from the motor terminal A while the wipers are operating.

4.  Verify that the wipers do not stop in the park position.

5.  Short between the motor terminals A and C, and connect battery positive voltage to the motor terminal E.

6.  Verify that the wipers operate at low speed again, then stop in the park position.

•  If there is any malfunction, replace the windshield wiper motor.