AFTER SERVICE PRECAUTION [MZI-3.7]

id0114d2800400

Warning

•  Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. When installing the fuel hose, observe “Fuel Leakage Inspection” described below.

Fuel Leakage Inspection

Warning

•  Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. Always carry out the following procedure with the engine stopped.

Using M-MDS

1.  Connect the M-MDS to the DLC-2.

ac9wzw00002169

2.  Using the simulation function “FP”, start the fuel pump. (See ON-BOARD DIAGNOSTIC TEST [MZI-3.7].)

3.  Verify that there is no fuel leakage from the pressurized parts.

4.  In the case of fuel leakage, replace the following components and then do the recheck by the fuel leakage checking procedure.

•  If there is leakage, replace the fuel hoses and clips.

•  If there is damage on the seal on the fuel pipe side, replace the fuel pipe.

Without using M-MDS

1.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZI-3.7].)

2.  Remove the fuel pump relay.

ac9wzw00001554

Caution

•  Short the specified terminals because shorting the wrong terminal of the main fuse block may cause malfunctions.

3.  Using a jumper wire, short fuel pump relay terminals C and D in the main fuse block.

ac9wzw00002170

4.  Connect the negative battery cable and operate the fuel pump. (See BATTERY REMOVAL/INSTALLATION [MZI-3.7].)

5.  Verify that there is no fuel leakage from the pressurized parts.

6.  In the case of fuel leakage, replace the following components and then do the recheck by the fuel leakage checking procedure.

•  If there is leakage, replace the fuel hoses and clips.

•  If there is damage on the seal on the fuel pipe side, replace the fuel pipe.