PCM REMOVAL/INSTALLATION [MZI-3.7]

id0140c3802400

Note

•  For replace the PCM, setup the M-MDS and perform the PCM configuration. (See PCM CONFIGURATION [MZI-3.7].)

1.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZI-3.7].)

2.  Remove the battery and battery tray. (See BATTERY REMOVAL/INSTALLATION [MZI-3.7].)

3.  Disconnect the PCM connectors.

4.  Remove the PCM and bracket as assembly.

ac9wzw00001733

5.  Remove in the order indicated in the table.

ac9wzw00002363

1	PCM bracket No.1
2	PCM
3	PCM bracket No.2

6.  Install in the reverse order of removal.

7.  When replacing the PCM on the vehicles, perform the following:

•  PCM parameter reset (See IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING [ADVANCED KEYLESS ENTRY AND START SYSTEM].)(See IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING [KEYLESS ENTRY SYSTEM].)