DSC/RSC SENSOR INITIALIZATION PROCEDURE

id041800816400

Warning

•  Unless the initialization procedure of the DSC/RSC HU/CM is completed, the DSC/RSC will not operate, causing an unexpected accident. Therefore, always perform the initialization procedure to ensure DSC/RSC operation if the DSC/RSC HU/CM or SAS control module have been removed or replaced.

1.  Inspect the wheel alignment and inflation pressure.

•  If there is any malfunction, adjust the applicable part.

2.  Park the vehicle on level ground.

3.  Turn the ignition switch to the OFF position.

4.  Connect the M-MDS to the DLC-2.

ac9uuw00000862

5.  After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

•  When using the IDS (laptop PC)

1.  Select “Chassis”.

2.  Select “ABS/DSC”.

3.  Select “Sensor Initialization”.

•  When using the PDS (Pocket PC)

1.  Select “Module Test”.

2.  Select “ABS”.

3.  Select “Datalogger”.

4.  Select “SSR_INTL”.

6.  Perform the initialization according to the directions on the screen.