DTC P0727:00 [AY6A-EL, AY6AX-EL]

id0502k1299500

DTC P0727:00

Engine speed input circuit no signal

DETECTION CONDITION

•  Conditions: TCM communication normal

•  Circumstances: Engine speed signal abnormality detected

•  Time period: Determined after 1 times

Diagnostic support note:

•  The MIL illuminates if the TCM detects the above malfunction condition during the first drive cycle.

•  The AT warning light illuminates.

•  PENDING CODE is not available.

•  FREEZE FRAME DATA is available.

•  The DTC is stored in the TCM memory.

FAIL-SAFE FUNCTION

•  Emergency mode 3

POSSIBLE CAUSE

•  PCM malfunction

SYSTEM WIRING DIAGRAM

—

DTC P0727:00	Engine speed input circuit no signal
DETECTION CONDITION	• Conditions: TCM communication normal • Circumstances: Engine speed signal abnormality detected • Time period: Determined after 1 times Diagnostic support note: • The MIL illuminates if the TCM detects the above malfunction condition during the first drive cycle. • The AT warning light illuminates. • PENDING CODE is not available. • FREEZE FRAME DATA is available. • The DTC is stored in the TCM memory.
FAIL-SAFE FUNCTION	• Emergency mode 3
POSSIBLE CAUSE	• PCM malfunction
SYSTEM WIRING DIAGRAM	—

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED • Has the FREEZE FRAME DATA been recorded on the repair order?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY • Verify related Service Information availability. • Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. • If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	VERIFY DTC IS PRESENT • Switch the ignition ON (Engine off). • Read the DTC in the PCM. • Are any DTCs stored?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [MZI-3.7].)
3		No	Go to the next step.
4	VERIFY DTC TROUBLESHOOTING COMPLETED • Make sure to reconnect all the disconnected connectors. • Clear the DTC using the M-MDS. • Perform the following procedure to ensure that the DTC has been resolved: 1. Start the engine. 2. Warm up the engine to normal operating temperature. 3. Drive the vehicle in D position for 0.5 s or more. • Is the same DTC present?	Yes	Repeat Step 3.
4		No	Go to the next step.
5	VERIFY NO DTCs ARE PRESENT • Perform the “Reading DTCs Procedure”. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [AY6A-EL, AY6AX-EL].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [AY6A-EL, AY6AX-EL].)
5		No	DTC troubleshooting completed.