DTC C1280, C1282, C1516, C2770

id080200820700

DTC

C1280

Yaw rate sensor in SAS control module is signal error

C1282

Low-G (XY) sensor (lateral-G) in SAS control module is signal error

C1516

Roll rate sensor in SAS control module is signal error

C2770

Low-G (XY) sensor (forward-G) in SAS control module is signal error
DETECTION CONDITION
Warning
•  Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection with only detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.
•  Malfunction in the SAS control module
POSSIBLE CAUSE
•  SAS control module malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION
1
PERFORM SAS CONTROL MODULE DTC INSPECTION
•  Clear the DTC for the SAS control module using the M-MDS.
•  Perform the DTC inspection for the SAS control module using the M-MDS.
•  Are the same DTCs present?
Yes
Replace the SAS control module.
(See SAS CONTROL MODULE REMOVAL/INSTALLATION.)
No
DTC troubleshooting completed.