DTC INSPECTION [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND START SYSTEM)]

id09021h345400

Security Light

1.  Turn the ignition switch to the ON position.

2.  Verify the security light state.

•  If there is any malfunction:

―  After any malfunction is detected, the security light will function as follows for approx. 1 min.

•  DTC 16 and lower: Flashes

•  DTC 21 and higher: Illuminated

•  If there is no malfunction:

―  The security light illuminates for approx. 3 s and goes out.

3.  When any malfunction has been detected, read DTCs via flashing patterns displayed after the security light flashes or is illuminated for approx. 1 min.

•  Perform troubleshooting according to the corresponding DTC inspection.

Note

•  A verified DTC is flashed 10 times repeatedly by the security light.

•  If multiple DTCs are verified, the security light displays only the smallest DTC.

M-MDS

1.  Connect the M-MDS to the DLC-2.

L.H.D.

ac9uuw00000633

R.H.D.

ac9wzw00000487

2.  After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

1.  Select “Self Test”.

2.  Select “Modules”.

3.  Select “RKE”.

3.  Verify the DTC according to the directions on the screen.

•  If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

4.  After completion of repairs, clear all DTCs stored in the keyless control module. (See CLEARING DTC [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND START SYSTEM)].)