No.5 DOOR GLASS STOPS BEFORE FULLY OPENING/CLOSING [POWER WINDOW SYSTEMS (EXTERIOR OPEN/CLOSE FUNCTION)]

id090361809000

5

Door glass stops before fully opening/closing

POSSIBLE CAUSE

•  Power window main switch malfunction

•  Power window subswitch malfunction

•  Power window motor malfunction

•  Battery malfunction (low voltage)

•  Door glass improper installation

•  Power window initialization procedure error

•  Keyless control module malfunction

•  BCM malfunction

•  Keyless entry system signal reception error (outside operation area, radio signal interference)

Diagnostic Procedure

Step	Inspection		Action
1	• Operate the door glass in auto/manual by operating the power window main switch/power window subswitch. • Does the door glass stop before fully opening/closing using either operation?	Yes	Inspect the following parts, and repair or replace. • Power window main switch (See POWER WINDOW MAIN SWITCH INSPECTION.) • Power window subswitch (See POWER WINDOW SUBSWITCH INSPECTION.) • Power window motor (See POWER WINDOW MOTOR INSPECTION.) • Battery (Low voltage) • Door glass (Installation condition)
1		No	Go to the next step.
2	• Inspect the operation of the door glass by repeating Step 1 above. • Does the door glass stop before fully opening/closing while in auto operation?	Yes	Perform the power window initialization procedure. (See POWER WINDOW SYSTEM INITIALIZATION PROCEDURE.)
2		No	Go to the next step.
3	• Open the door glass by operating the transmitter. • Does the door glass stop before fully opening?	Yes	Inspect the following parts, and repair or replace. • Keyless control module (See KEYLESS CONTROL MODULE INSPECTION [ADVANCED KEYLESS ENTRY AND START SYSTEM].) • BCM (See BODY CONTROL MODULE (BCM) INSPECTION.) • Keyless entry system signal reception error (Outside operation area, radio signal interference.)
3		No	Go to the next step.
4	• Close the door glass by operating the transmitter. • Does the door glass stop before fully closing?	Yes	Inspect the following parts, and repair or replace. • Keyless control module (See KEYLESS CONTROL MODULE INSPECTION [ADVANCED KEYLESS ENTRY AND START SYSTEM].) • BCM (See BODY CONTROL MODULE (BCM) INSPECTION.) • Keyless entry system signal reception (the system is in outside operation area and/or influenced radio signal interference intermittently)
4		No	Reinspect for malfunction recurrence. If the malfunction is not corrected, repeat the procedure from Step 1.