C-PILLAR TRIM REMOVAL/INSTALLATION
id091700802200
1. Disconnect the negative battery cable.
2. Remove the following parts:
- (1) Trunk box (See TRUNK BOX REMOVAL/INSTALLATION.)
- (2) Seat side box (See SEAT SIDE BOX REMOVAL/INSTALLATION.)
- (3) Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)
- (4) Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION.)
- (5) Third-row seat belt lower anchor installation bolt (See THIRD-ROW SEAT BELT REMOVAL/INSTALLATION.)
- (6) Rear scuff plate inner (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)
- (7) Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
- (8) Second-row seat belt upper anchor installation bolt (See SECOND-ROW SEAT BELT REMOVAL/INSTALLATION.)
- (9) Roof side trim (See ROOF SIDE TRIM REMOVAL/INSTALLATION.)
3. Partially peel back the seaming welt.
4. Remove the cover in the direction of the arrow.
5. Remove the bolt.
6. Detach clip A and tab B, and pin C by pulling them in the direction of the arrow.
7. Remove the C-pillar trim.
8. Install in the reverse order of removal.
