ANTENNA FEEDER NO.2 INSPECTION

id092000812500

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  Front scuff plate inner (RH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Front side trim (RH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)  Liftgate upper trim (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION.)

3.  Disconnect the antenna feeder No.1. (See ANTENNA FEEDER NO.1 REMOVAL/INSTALLATION.)

4.  Disconnect the antenna feeder No.2 connector. (See ANTENNA FEEDER NO.2 REMOVAL/INSTALLATION.)

5.  Verify that the continuity between antenna feeder No.2 terminals is as indicated in the table.

ac9wzw00000899

•  If not as indicated in the table, replace antenna feeder No.2.

ac9wzw00000900