PRE-DELIVERY INSPECTION


id000000702100


Refer To The Workshop Manual For Detailed Adjustment Procedures

•  The steps in this inspection sheet are designed for efficient movement around the vehicle.
•  Problems found during inspection should be noted on a repair order.
•  Unless otherwise stated, each item should be inspected for fit, appearance and/or operation.
•  Inspection items followed by an asterisk (*) are required only if the vehicle is equipped with that feature.

Pre-Delivery Inspection Table


General

qCheck vehicle for any open Recalls, SSPs, or MSPs, and available updates for audio/navigation systems
qInstall/assemble all loose or packaged parts in the glove box and trunk/cargo area


Exterior

INSPECT and ADJUST, if necessary, the following items to specification:
qREMOVE all protective wrap, covers, and window stickers
qGlass, exterior bright metal and paint for damage
qDoor and liftgate* operation (Open/Close)
qAll weather strips for damage or detachment
qSecurity/keyless entry devices*
qAdvanced keyless entry*
qOperation of bonnet release and lock, trunk release, and fuel-filler lid opener


Under bonnet

INSPECT and ADJUST, if necessary, the following items:
qINSTALL Fuses for accessories
•  25A fuse (Relay and fuse block F27)
qCoolant, and hydraulic lines, fittings, connections, and components for leaks
qBrake fluid level
qWindshield washer reservoir fluid level
qHeadlight cleaner (if equipped)*
qRadiator/Water-cooled charge air cooler* coolant level
qTightness of battery terminals, electrolyte level and voltage (12.4 V)


Interior

INSPECT the operations of the following items:
qSecure floor mats to hooks.
qParking brake
qVerify that warning lights (check EV system, brake, charging system, ABS, TPMS) stay on for a few seconds after switch the main power ON (READY off or on)
qPerform emergency call control module finalization (If the indicator of the emergency call switch illuminate ON and OFF (flash) repeatedly.)
qHorn, front/rear wipers, and washers. Wiper blades performance (Clean wiper blades and windshield, if necessary).
qInterior and exterior lights, dash switches, headlight leveling switch. Set position to 0.
qAudio system (Power/Volume/sound controls, Radio, CD player, including steering wheel audio controls
qHeater and A/C (driver, passenger) and front defroster in all mode settings
qTurn on navigation system.*
qAdjust clock, dashboard panel and navigation system
qPower window initialization (if battery was discharged during inventory storage).
qDoor locks
INSPECT the following items:
qUpholstery and interior finish
qCheck operation of any dealer installed accessories


ON hoist

INSPECT the following items:
qREMOVE under cover
qTires for cuts or bruises
qUnderside, coolant and hydraulic lines, fittings, connections, and components for leaks
qSteering linkage, suspension, exhaust system, and all underside hardware for looseness or damage
qINSTALL under cover


Lower Vehicle And Remove From Lift

qTire pressures (See tire label located on driver’s side B-pillar or edge driver’s of door frame for specification.)
qFlat tire repair kit*

Tire pressure record
Left front
Right front
Left rear
Right rear
 
 
 
 


Road test

INSPECT the following items:
qSteering operation (steering wheel centered, drift or pull, and power assist)
qBrake operation
qSqueaks, rattles, and abnormal noises
qWarning lights are off
qVerify navigation system receives GPS signal (vehicle follows map)*


After road test

The following items must be completed just before delivery to your customer.
qTire pressures (See tire label located on driver’s side B-pillar or edge driver’s of door frame for specification.)

Tire pressure record
Left front
Right front
Left rear
Right rear
 
 
 
 

•  Unless the vehicle is scheduled for display or immediate delivery, do not remove the exterior protective film or interior protective covering during inspection
qAfter washing and drying the vehicle, perform appearance checks before delivery

APPEARANCE CHECKS BEFORE DELIVERY

In addition to function checks, also perform one last inspection of key areas of the vehicle to ensure they are clean and free of chips and scratches.
Check and repair chips and scratches:
Remove dirt and scratches from key areas:
qDoor edges
qAround door handles
qDoor dings and dents
qBonnet leading edges
qBumper covers
qDoor sill scuff plates
qDoor inner panel
qSeats
qCarpets and floor mats
qSteering wheel
qCenter console