VEHICLE CONTROL MODULE (VCM) INITIAL SETTING

id094000700600

1.  Connect the M-MDS to the DLC-2.

2.  Switch the main power ON (READY off).

3.  Activate the M-MDS and perform the following procedure.

(1)  Press [Start] to start the vehicle identification.

(2)  Press the [Toolbox] tab.

(3)  Press the [Work Support] icon.

(4)  Press [BRAKES].

(5)  Press [Run] for [Calibrating Yaw Rate for VCM].

(6)  Confirm the Calibrating Yaw Rate for VCM procedure from Step (7) to Step (10) and press [Next].

(7)  Verify that the main power is switched ON (READY off) and press [Next].

(8)  Press [Next] to perform [Calibrating Yaw Rate for VCM].

(9)  When the M-MDS processing is completed, press [Next].

(10)  Press [Next] to complete [Calibrating Yaw Rate for VCM].