DTC INSPECTION

id990200000300

Quick Check

1.  Connect the M-MDS to the DLC-2.

2.  Switch the main power ON (READY off or on).

3.  Perform the following procedure using the M-MDS.

1.  Press [Start] for the vehicle identification.

2.  Press the [Quick Check] tab.

4.  Verify DTCs following the instructions on the screen.

•  If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection after recording the snapshot data.

Note

•  Each module condition can be determined by the color of the displayed module.

―  Green: No DTCs

―  Red: Communication Error

―  Blue: No Communication or Not Equipped

―  Orange: DTC(s) exist

―  Gray: DTC Not Supported

•  If a module displayed in orange (DTC(s) exist) is selected, the DTCs stored in the selected module are displayed in a list.

•  If the following icon is selected, the DTCs stored in all the modules are displayed in a list.

aaxjjw00026463

•  If the following icon is selected on the DTC list screen, the snapshot data relative to the applicable DTC is displayed.

aaxjjw00026464

On-demand Self-test

1.  Connect the M-MDS to the DLC-2.

2.  When performing the body control module (BCM) self-test, verify that the vehicle is under the following conditions.

When performing the KOEO On-Demand self-test for Door Lock System:

•  All doors, hood, liftgate are closed

•  All doors are unlocked

When performing the KOEO On-Demand self-test for Lighting Systems:

•  Hazard warning switch is off

•  Light switch is off

•  Rear window defogger switch is off

•  Shift position is in position other than R

3.  Switch the main power ON (READY off or on).

4.  Perform the following procedure using the M-MDS.

1.  Press [Start] for the vehicle identification.

2.  Press the [Toolbox] tab.

3.  Press the [Diagnosis] icon.

4.  Press [On-demand self-test].

5.  Press the applicable [M-MDS display name] from the module table. (See Module table.)

6.  Press [Run] for the applicable [Self-test type] from the module table. (See Module table.)

5.  Verify DTCs following the instructions on the screen.

•  If a DTC is displayed, repair the malfunctioning location according to the applicable DTC troubleshooting.

Module table