SIMULATION INSPECTION

id990200000600

1.  Connect the M-MDS to the DLC-2.

2.  Switch the main power ON (READY off or on).

3.  Perform the following procedure using the M-MDS.

1.  Press [Start] for the vehicle identification.

2.  Press the [Toolbox] tab.

3.  Press the [Diagnosis] icon.

4.  Press [Run] for Data Logger.

4.  Select the applicable module according to the module table. (See Module Table.)

5.  Select the applicable simulation item.

Note

•  The simulation function can only be implemented on items displaying the following icon.

aaxjjw00026461

6.  Inspect the operation of each part according to the directions on the screen.

Note

•  If the operation of the output part cannot be verified as a result of implementing the simulation function, an open/short circuit, sticking, or operation malfunction with the output part can be considered.

Module Table

M-MDS display name	Applicable module
ADD	Active driving display
ALH/AFS/ALV	Adaptive LED headlights control module
	Adaptive front lighting system (AFS) control module
	Auto leveling control module
BCM	Body control module (BCM)
DASH_ESU	Dash-electrical supply unit
IC	Instrument cluster
LFU	LF control unit
PCM	PCM
MHB	BECM
HP	Heat pump control unit