i-stop OFF SWITCH INSPECTION [SKYACTIV-G 2.0]

id0140f4888900

Note

• The i-stop OFF switch is integrated with the cluster switch No.1.

• For the i-stop OFF switch removal/installation, refer to CLUSTER SWITCH REMOVAL/INSTALLATION. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)

1. Connect the M-MDS to the DLC-2.

2. Perform the DTC inspection for the instrument cluster. (See DTC INSPECTION.)

• If DTCs are detected, repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [BODY CONTROL MODULE (BCM)].)

• If DTCs are not detected, go to the next step.

3. Display the PCM PID [I-STOP_OFF_SW]. (See PID/DATA MONITOR INSPECTION.)(See PID/DATA MONITOR TABLE [PCM (SKYACTIV-G)].)

4. While operating the i-stop OFF switch, verify that the [I-STOP_OFF_SW] changes as shown in the following.

Test condition

Data contents (I-STOP_OFF_SW)

i-stop OFF switch is pressed

On

Except above

Off

• If not within the specification, replace the cluster switch No.1. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)

• If it can be verified, the i-stop OFF switch is normal therefore the inspection is completed.

Test condition	Data contents (I-STOP_OFF_SW)
i-stop OFF switch is pressed	On
Except above	Off