TRANSFER OIL INSPECTION [ET6AX-EL]

id0316j1700200

Replacement Part

Washer
 
Quantity: 1
 
Location of use: Oil level plug

Oil and Chemical Type

Transfer oil
 
MAZDA LONG LIFE HYPOID GEAR OIL SG1

1.  Remove the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

2.  Remove the front crossmember component. (See FRONT CROSSMEMBER REMOVAL/INSTALLATION.)

3.  Remove the exhaust manifold (WU-TWC). (See EXHAUST SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

4.  Remove the heat shield. (See TRANSFER REMOVAL/INSTALLATION [ET6AX-EL].)

5.  Remove the transfer bracket. (See TRANSFER REMOVAL/INSTALLATION [ET6AX-EL].)

6.  Remove the oil level plug and with the washer.

ac30zw00001918

7.  Verify that there is transfer oil around the oil level plug installation hole by hand.

•  If there is a lack of oil, add transfer oil from the oil level plug installation hole.

Transfer oil type

MAZDA LONG LIFE HYPOID GEAR OIL SG1

8.  Install the oil level plug with a new washer.

ac30zw00001919

9.  Install the transfer bracket. (See TRANSFER REMOVAL/INSTALLATION [ET6AX-EL].)

10.  Install the heat shield. (See TRANSFER REMOVAL/INSTALLATION [ET6AX-EL].)

11.  Install the exhaust manifold (WU-TWC). (See EXHAUST SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

12.  Install the front crossmember component. (See FRONT CROSSMEMBER REMOVAL/INSTALLATION.)

13.  Install the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)