DTC P0500:00 [TCM (ET6A-EL, ET6AX-EL)]

id0502q9321400

Outline

System malfunction location

Vehicle speed signal circuit malfunction
Detection condition
•  Under the following conditions, the vehicle speed signal input from electronically controlled brake unit is incorrect:
―  Engine is running.
―  The vehicle is driven in D position or R position.
―  Output shaft speed sensor related DTC is not recorded
―  There is correlation between output shaft speed sensor speed and turbine/input shaft speed sensor speed.
Fail-safe
•  Inhibits learning control.
•  Inhibits neutral idle control.
•  Inhibits i-stop control.
•  Inhibits AAS.
Possible cause
•  Electronically controlled brake unit DTC is stored.
―  ABS wheel-speed sensor malfunction
System wiring diagram
•  Not applicable
Connector diagram
•  Not applicable

Diagnostic Procedure

Step

Inspection

Results

Action
1
RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
•  Record the freeze frame data/snapshot data.
Note
•  Recording can be facilitated using the screen capture of the PC function.
—
Go to the next step.
2
VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY
•  Verify related Service Bulletins, on-line repair information, or Service Information availability.
•  Is any related information available?
Yes
Perform repair or diagnosis according to the available information.
•  If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3
VERIFY STORED DTC IN ELECTRONICALLY CONTROLLED BRAKE UNIT
•  Perform the electronically controlled brake unit DTC inspection using the M-MDS.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [ELECTRONICALLY CONTROLLED BRAKE UNIT].)
No
Go to the next step.
Repair completion verification
VERIFY DTC TROUBLESHOOTING COMPLETED
•  Clear the DTC using the M-MDS.
•  Perform the following procedure to ensure that the DTC has been resolved:
1.  Drive the vehicle for 10 s or more under the following conditions:
•  Battery voltage: 8 V or more
•  Vehicle speed: 45 km/h {28 mph} or more
•  Perform the DTC inspection using the M-MDS.
•  Are any DTCs present?
Yes
Repair the malfunctioning location according to the applicable DTC troubleshooting.
(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (ET6A-EL, ET6AX-EL)].)
No
DTC troubleshooting completed.