DTC U0415:00 [ELECTRIC POWER STEERING (EPS) CONTROL MODULE]

id0602a6814400

Outline

System malfunction location

Signal error from electronically controlled brake unit

Detection condition

•  Error detected in signal from electronically controlled brake unit via CAN communication

Fail-safe

•  Refer to “Fail-safe Function Table”. (See DTC TABLE [ELECTRIC POWER STEERING (EPS) CONTROL MODULE].)

Possible cause

•  Electronically controlled brake unit malfunction

System wiring diagram

Not applicable

Connector diagram

Not applicable

Diagnostic Procedure

Step

Inspection

Results

Action

1

VERIFY ELECTRONICALLY CONTROLLED BRAKE UNIT DTC

•  Using the M-MDS, perform the electronically controlled brake unit DTC inspection.
(See DTC INSPECTION.)

•  Are any DTCs present?

Yes

Go to the applicable DTC inspection.

(See DTC TABLE [ELECTRONICALLY CONTROLLED BRAKE UNIT].)

DTC troubleshooting completed, then perform the repair completion verification.

No

Go to the next step.

Repair completion verification

VERIFY DTC TROUBLESHOOTING COMPLETED

•  Using the M-MDS, clear the DTC from the Electric Power Steering (EPS) control module.
(See CLEARING DTC.)

•  Using the M-MDS, perform the Electric Power Steering (EPS) control module DTC inspection.
(See DTC INSPECTION.)

•  Is the same Pending DTC present?

Yes

Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.

(See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW.)

If the CAN communication is normal, perform the diagnosis from Step 1.

•  If the malfunction recurs, replace the electronically controlled brake unit.
(See ELECTRONICALLY CONTROLLED BRAKE UNIT REMOVAL/INSTALLATION.)

No

DTC troubleshooting completed.

System malfunction location		Signal error from electronically controlled brake unit
Detection condition		• Error detected in signal from electronically controlled brake unit via CAN communication
Fail-safe		• Refer to “Fail-safe Function Table”. (See DTC TABLE [ELECTRIC POWER STEERING (EPS) CONTROL MODULE].)
Possible cause		• Electronically controlled brake unit malfunction
System wiring diagram		Not applicable
Connector diagram		Not applicable

Step	Inspection	Results	Action
1	VERIFY ELECTRONICALLY CONTROLLED BRAKE UNIT DTC • Using the M-MDS, perform the electronically controlled brake unit DTC inspection. (See DTC INSPECTION.) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [ELECTRONICALLY CONTROLLED BRAKE UNIT].) DTC troubleshooting completed, then perform the repair completion verification.
1		No	Go to the next step.
Repair completion verification	VERIFY DTC TROUBLESHOOTING COMPLETED • Using the M-MDS, clear the DTC from the Electric Power Steering (EPS) control module. (See CLEARING DTC.) • Using the M-MDS, perform the Electric Power Steering (EPS) control module DTC inspection. (See DTC INSPECTION.) • Is the same Pending DTC present?	Yes	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW.) If the CAN communication is normal, perform the diagnosis from Step 1. • If the malfunction recurs, replace the electronically controlled brake unit. (See ELECTRONICALLY CONTROLLED BRAKE UNIT REMOVAL/INSTALLATION.)
Repair completion verification		No	DTC troubleshooting completed.