AUTOMATIC TRANSMISSION ON-BOARD DIAGNOSTIC FUNCTION [SJ6A-EL]

DTC Reading Procedure

1. Perform necessary vehicle preparation and visual inspection.

2. Connect the M-MDS to the DLC-2.

3. After the vehicle is identified, select the following items from the initial screen of the M-MDS.

• When using the IDS (laptop PC)

1. Select the "Toolbox" tab.

2. Select "Self Test".

3. Select "Modules".

4. Select "TCM".

• When using the PDS (Pocket PC)

1. Select "Module Tests".

2. Select "TCM".

3. Select "Self Test".

4. Verify the DTC according to the directions on the screen.

• If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

5. After completion of repairs, clear all DTCs stored in the TCM. (See AFTER REPAIR PROCEDURE [SJ6A-EL].)