|
STEP
|
INSPECTION
|
ACTION
|
|
1
|
• Start the engine.
• Does the oil pressure gauge needle indicate L position or more?
|
Yes
|
Troubleshooting completed.
|
|
No
|
Go to the next step.
|
|
2
|
• Do the speedometer, the tachometer, and the water temperature gauge operate normally?
|
Yes
|
Go to the next step.
|
|
No
|
Go to Step 5.
|
|
3
|
• Does the engine oil need replenishment?
|
Yes
|
Add the engine oil.
|
|
No
|
Go to the next step.
|
|
4
|
• Start the instrument cluster input/output check mode.
• Inspect the oil pressure gauge using the check code 28.
• Is the oil pressure gauge normal?
|
Yes
|
Inspect the PCM, oil pressure switch, or connectors.
|
|
No
|
Replace the instrument cluster.
|
|
5
|
• Start the engine.
• Does the ABS warning light turn off?
|
Yes
|
Inspect the PCM or connectors.
|
|
No
|
Go to the next step.
|
|
6
|
• Disconnect the negative battery cable.
• Measure the resistance between the DLC-2 terminals F and E.
• Is the resistance 54-66 ohms?
|
Yes
|
Go to the next step.
|
|
No
|
Go to Step 8.
|
|
7
|
• Disconnect the negative battery cable.
• Inspect the DLC-2 terminals F and E for short to power supply or GND.
• Is there any malfunction?
|
Yes
|
Inspect the wiring harness and CAN system-related module.
Repair or replace the malfunctioning part.
|
|
No
|
Replace the instrument cluster.
|
|
8
|
• Turn the ignition switch off.
• Inspect the instrument cluster connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion).
• Are the terminals normal?
|
Yes
|
Go to the next step.
|
|
|
No
|
Repair or replace the terminal.
|
|
9
|
• Disconnect the negative battery cable.
• Measure the resistance between the instrument cluster connector terminals 1J and 1L.
• Is the resistance 114-126 ohms?
|
Yes
|
Inspect the wiring harness and CAN system-related module.
Repair or replace the malfunctioning part.
|
|
No
|
Replace the instrument cluster.
|