1. Remove the battery cover.
2. Disconnect the negative battery cable. BATTERY REMOVAL/INSTALLATION [L8, LF].)
3. Remove the partition board. (See PARTITION BOARD REMOVAL/INSTALLATION.)
4. Disconnect the high-mount brake light connector.
5. Press the tabs and remove the clips.
6. Install in the reverse order of removal.
1. Fully open the deck panel.
2. Partially peel back the seal cover.
3. Disconnect the high-mount brake light connector.
4. Remove the wiring harness and connector of the high-mount brake light from the deck panel.
5. Remove the nuts.
6. Remove the high-mount brake light.
7. Install in the reverse order of removal.
