INSTRUMENT CLUSTER CONFIGURATION

id092200496200

1.  Connect the M-MDS to the DLC-2 connector.

amxzzw00002513

2.  After the vehicle is identified, select the following items from the initial screen of the M-MDS.

•  When using the IDS (laptop PC)

1.  Select “Module Programming”.

•  When using the PDS (Pocket PC)

1.  Select “Programming”.

2.  Select “Module Programming”.

3.  Select “Programmable Module Installation”.

4.  Select “IC” and perform procedures according to directions on the M-MDS screen.

5.  Retrieve DTCs using the M-MDS and verify that there is no DTC present.

•  If any DTC is present, perform applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER].)