DTC B2143
id020200800400
|
DESCRIPTION |
ID registration failure |
|---|---|
|
DETECTION CONDITION
|
• Two or more codes are overlapping.
|
|
POSSIBLE CAUSE
|
• ID registration procedure has not been performed properly.
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY PROGRAMMED ID
• Turn the ignition switch off.
• Connect the M-MDS to the DLC-2.
• Perform the PID/Data Monitor and Record Procedure and select the following PIDs using the M-MDS:
• Turn the ignition switch to the ON position.
• Is the same code in the output ID?
|
Yes
|
Perform the instrument cluster configuration, register the wheel unit ID, and then go to the next step.
(See WHEEL UNIT ID REGISTRATION.)
|
|
No
|
Go to the next step.
|
||
|
2
|
VERIFY TROUBLESHOOTING COMPLETED
• Perform the Clearing DTCs Procedure.
• Drive the vehicle at a speed of 25 km/h {15.5 mph} or more for 10 min or more.
• Perform the Reading DTCs Procedure.
• Is the same DTC present?
|
Yes
|
Repeat the inspection from Step 1.
If the malfunction recurs:
• Replace the instrument cluster and/or wheel unit, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY AFTER REPAIR PROCEDURE
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||