AUTOMATIC TRANSMISSION ON-BOARD DIAGNOSTIC FUNCTION [SJ6A-EL]

id050208811100

Reading DTCs Procedure

1.  Connect the M-MDS to the DLC-2.

L.H.D.

amxzzw00000862

R.H.D.

amxzzw00000863

2.  After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

1.  Select "Self Test".

2.  Select "Modules".

3.  Select "TCM".

1.  Select "Module Tests".

2.  Select "TCM".

3.  Select "Self Test".

Note

•  Freeze frame data appears at the top of the help screen when the displayed DTC is selected.

•  The freeze frame data consists of data for vehicle and transmission control system operation conditions when malfunctions in the transmission control system are detected and stored in the TCM.

•  There are modes 2 and 12 in the freeze frame data.

Freeze frame data (mode 2)

―  Freeze frame data is stored at the instant the malfunction indicator lamp illuminates, and only a part of the DTC data is stored.

―  For the freeze frame data, if there are several malfunctions in the engine control system, the data for the malfunction which occurred initially is stored. Thereafter, if a misfire or fuel injection control malfunction occurs, data from the misfire or fuel injection control malfunction is written over the initially stored data. However, if the initially stored freeze frame data is a misfire or fuel injection control malfunction, it is not overwritten.

Freeze frame data (mode 12)

―  The data for DTCs currently detected is stored.

―  The DTC recording timing differs depending on the number of DTC drive cycles.

•  For a DTC with a drive cycle number 1, only the malfunction determination data is recorded.

•  For a DTC with a drive cycle number 2, both the malfunction determination and undetermined data is recorded.

3.  Verify the DTC according to the directions on the M-MDS screen.

Freeze frame data table (mode2, mode12) table

Note

•  Refer to PID monitor table for confirm the engine control system operation status while the PCM does not store the DTC.

•  Freeze frame data items are not displayed, according to detected DTC.

Freeze frame data item	Definition	Unit	Corresponding PID data monitor item	Description
LOAD	Engine load	%	—	Ratio of current intake air amount to wide-open throttle engine operation intake air amount
ECT	Engine coolant temperature	°C	ECT TCM	Engine coolant temperature
RPM	Engine speed	Rpm	RPM TCM	Engine speed
VS	Vehicle speed	KPH	VSS	Vehicle speed input from ABS/DSC HU/CM
TP	Throttle valve position No.1	%	THOP	TP sensor No.1 value
RUNTM	Time from engine start	hh:mm:ss	—	Time from engine start
VPWR	Module supply voltage	V	VPWR_TCM	PCM power supply voltage

Clearing DTCs Procedure

1.  Connect the M-MDS to the DLC-2.

L.H.D.

amxzzw00000862

R.H.D.

amxzzw00000863

2.  After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

1.  Select "Self Test".

2.  Select "Modules".

3.  Select "TCM".

1.  Select "Module Tests".

2.  Select "TCM".

3.  Select "Self Test".

3.  Verify the DTC according to the directions on the M-MDS screen.

4.  Press the clear button on the DTC screen to clear the DTC.