DTC U3000:49 [SAS CONTROL MODULE (ACTIVE BONNET)]

id0802h4824800

System malfunction location	SAS control module internal malfunction
Detection condition	Warning •  Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure. •  SAS control module internal circuit has a malfunction
Fail-safe function	Not applicable
Possible cause	•  SAS control module malfunction
System wiring diagram	Not applicable

Diagnostic Procedure

STEP	INSPECTION		ACTION
1	PERFORM SAS CONTROL MODULE DTC INSPECTION •  Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC [SAS CONTROL MODULE (ACTIVE BONNET)].) •  Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION [SAS CONTROL MODULE (ACTIVE BONNET)].) •  Is the same Pending DTC present?	Yes	Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION.)
		No	DTC troubleshooting completed.