ION SENSOR INSPECTION [SKYACTIV-G 1.5, SKYACTIV-G 2.0]

id0140g8954700

DTC Inspection

1.  Connect the M-MDS to the DLC-2.

2.  Perform the DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 1.5, SKYACTIV-G 2.0)].)

•  If any DTC related to the ignition coil/ion sensor is present, repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [PCM (SKYACTIV-G 1.5, SKYACTIV-G 2.0)].)

Visual Inspection

Note

•  The ion sensor is built into the ignition coil. When replacing the ion sensor, replace the ignition coil/ion sensor.

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2.  Remove the ignition coil/ion sensor. (See IGNITION COIL/ION SENSOR REMOVAL/INSTALLATION [SKYACTIV-G 1.5, SKYACTIV-G 2.0].)

3.  Verify that there is no damage to the ignition coil/ion sensor, and no corrosion and damage to the connector.

•  If there is a malfunction, replace the ignition coil/ion sensor. (See IGNITION COIL/ION SENSOR REMOVAL/INSTALLATION [SKYACTIV-G 1.5, SKYACTIV-G 2.0].)