GENERAL PROCEDURES (BRAKE)

id041000800100

Wheel And Tire Installation

1.  When installing the wheels and tires, tighten the wheel nuts to the following tightening torque in the order shown in the figure.

amxuuw00005040

Brake Lines Disconnection

1.  If any brake line has been disconnected during the procedures, add brake fluid, bleed the brakes, and inspect for leakage after the procedure has been completed.

Caution

•  Brake fluid will damage painted surfaces. Be careful not to spill any on painted surfaces. In addition, if there is any brake fluid on the wiring harness, the wire insulation may corrode causing a malfunction such as a short circuit. If brake fluid gets on a painted surface or wiring harness, wash and flush it off completely with water immediately.

Brake Pipe Flare Nut Tightening

1.  Tighten the brake pipe flare nut using any commercially available flare nut wrench.

DSC Related Parts

1.  Verify that there are no DTCs in the DSC memory after working on DSC related parts. If there are any DTCs in the memory, clear them. (See CLEARING DTC [DSC HU/CM].)

DSC Related Part Sensor Initialization Procedure

Warning

•  If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, when replacing the following parts, make sure to perform the initialization procedure to insure proper DSC operation.

1.  When replacing the following parts, perform the initialization procedure. (See DSC RELATED PARTS SENSOR INITIALIZATION PROCEDURE.)

•  DSC HU/CM

•  SAS control module