 |
amxzzw00002834
EPS CONTROL MODULE INSPECTION
id061300802400
1. Measure the voltage of the EPS control module using a tester.
amxzzw00002834
|
Terminal Voltage Table (Reference)
|
Terminal |
Connected to |
Test condition |
Specification (Reference) |
Inspection item |
|---|---|---|---|---|
|
1A
|
Battery (without i-ELOOP)
|
Under any condition
|
B+
|
• Inspect the battery.
(See BATTERY INSPECTION.)
• Inspect related wiring harness.
|
|
DC-DC converter (with i-ELOOP)
|
Under any condition
|
B+
|
• Inspect the DC-DC converter.
• Inspect related wiring harness.
|
|
|
2A
|
IG1 relay
|
Ignition off
|
1.0 V or less
|
• Inspect the IG1 relay.
(See RELAY INSPECTION.)
• Inspect related wiring harness.
|
|
Ignition ON (engine off)
|
B+
|
|||
|
2B
|
CAN related module
|
Because this terminal is for communication, determination using terminal voltage inspection is not possible. Perform the inspection using the DTC inspection.
|
||
|
2C
|
CAN related module
|
Because this terminal is for communication, determination using terminal voltage inspection is not possible. Perform the inspection using the DTC inspection.
|
||