DTC B1D9E:79 [RETRACTABLE HARDTOP CONTROL MODULE]
id0902r4075900
Description |
Exceeds maximum number of pulse counts for rear roof link motor (LH) |
---|---|
Detection condition
|
• The retractable hardtop control module detects a pulse signal exceeding the maximum number of the pulse counts from the rear roof link motor (LH).
|
Fail-safe
|
• Stops retractable hardtop operation
|
Possible cause
|
• Rear roof link motor (LH) is disengaged from rear roof link (motor idling)
• Rear roof link motor (LH) malfunction
• Retractable hardtop control module malfunction
|
System wiring diagram
|
Not applicable
|
Diagnostic Procedure
Step |
Inspection |
Action |
|
---|---|---|---|
1
|
VERIFY OTHER RETRACTABLE HARDTOP CONTROL MODULE DTCs
• Clear the DTC for the retractable hardtop control module using the M-MDS.
• Retrieve the retractable hardtop control module DTCs using the M-MDS.
• Is the DTCs U3000:44/U3000:45/U3000:49 displayed?
|
Yes
|
Replace the retractable hardtop control module, then go to Step 4.
|
No
|
Go to the next step.
|
||
2
|
INSPECT REAR ROOF LINK
• Verify if the rear roof link motor (LH) is disengaged from the rear roof link.
• Is the rear roof link motor (LH) disengaged from the rear roof link?
|
Yes
|
Install the rear roof link motor (LH) to the correct position, then go to Step 4.
|
No
|
Go to the next step.
|
||
3
|
INSPECT REAR ROOF LINK MOTOR (LH)
• Inspect the rear roof link motor (LH).
• Is the rear roof link motor (LH) normal?
|
Yes
|
Go to the next step.
|
No
|
Replace the rear roof link motor (LH), then go to the next step.
|
||
4
|
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
• Clear the DTC for the retractable hardtop control module using the M-MDS.
• Retrieve the retractable hardtop control module DTCs using the M-MDS.
• Is the same DTC displayed?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the retractable hardtop control module.
Go to the next step.
|
No
|
Go to the next step.
|
||
5
|
VERIFY IF OTHER DTCs DISPLAYED
• Are any other DTCs displayed?
|
Yes
|
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
|
No
|
DTC troubleshooting completed.
|