DTC B1D9F:74 [RETRACTABLE HARDTOP CONTROL MODULE]

id0902r4076100

Description

Rear roof link motor (LH) operation time-out

Detection condition

•  The retractable hardtop control module detects that the rear roof link motor (LH) is operating for 10 s or more.

Fail-safe

•  Stops retractable hardtop operation

Possible cause

•  Retractable hardtop control module malfunction

•  Foreign matter penetrates raer roof link

•  Rear roof link motor (LH) malfunction

System wiring diagram

Not applicable

Description	Rear roof link motor (LH) operation time-out
Detection condition	• The retractable hardtop control module detects that the rear roof link motor (LH) is operating for 10 s or more.
Fail-safe	• Stops retractable hardtop operation
Possible cause	• Retractable hardtop control module malfunction • Foreign matter penetrates raer roof link • Rear roof link motor (LH) malfunction
System wiring diagram	Not applicable

Diagnostic Procedure

Step	Inspection		Action
1	VERIFY OTHER RETRACTABLE HARDTOP CONTROL MODULE DTCs • Clear the DTC for the retractable hardtop control module using the M-MDS. (See CLEARING DTC [RETRACTABLE HARDTOP CONTROL MODULE].) • Retrieve the retractable hardtop control module DTCs using the M-MDS. (See DTC INSPECTION [RETRACTABLE HARDTOP CONTROL MODULE].) • Is the DTCs U3000:44/U3000:45/U3000:49 displayed?	Yes	Replace the retractable hardtop control module, then go to Step 4. (See RETRACTABLE HARDTOP CONTROL MODULE REMOVAL/INSTALLATION.)
1		No	Go to the next step.
2	INSPECT REAR ROOF LINK • Visually inspect the raer roof link for foreign matter. • Has foreign matter penetrated the raer roof link?	Yes	Remove foreign matter from the raer roof link, then go to Step 4.
2		No	Go to the next step.
3	INSPECT REAR ROOF LINK MOTOR (LH) • Inspect the raer roof link motor (LH). (See REAR ROOF LINK MOTOR INSPECTION.) • Is the raer roof link motor (LH) normal?	Yes	Go to the next step.
3		No	Replace the raer roof link motor (LH), then go to the next step. (See REAR ROOF LINK MOTOR REMOVAL/INSTALLATION.)
4	VERIFY THAT REPAIRS HAVE BEEN COMPLETED • Clear the DTC for the retractable hardtop control module using the M-MDS. (See CLEARING DTC [RETRACTABLE HARDTOP CONTROL MODULE].) • Retrieve the retractable hardtop control module DTCs using the M-MDS. (See DTC INSPECTION [RETRACTABLE HARDTOP CONTROL MODULE].) • Is the same DTC displayed?	Yes	Repeat the inspection from Step 1. • If the malfunction recurs, replace the retractable hardtop control module. (See RETRACTABLE HARDTOP CONTROL MODULE REMOVAL/INSTALLATION.) Go to the next step.
4		No	Go to the next step.
5	VERIFY IF OTHER DTCs DISPLAYED • Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [RETRACTABLE HARDTOP CONTROL MODULE].)
5		No	DTC troubleshooting completed.