STEERING ANGLE SENSOR INSPECTION

id041500801700

1.  Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION.)

2.  Measure the voltage between steering angle sensor terminal B and ground.

amxzzw00000276

•  If there is any malfunction, inspect the wiring harness between steering angle sensor terminal B and battery, then repair or replace if necessary.

3.  Turn the ignition switch to the ON position, then measure the voltage between steering angle sensor terminal A and ground.

•  If there is any malfunction, inspect the wiring harness between steering angle sensor terminal A and ignition switch, then repair or replace if necessary.

4.  Measure the voltage between steering angle sensor terminal H and the ground.

•  If there is any malfunction, inspect the wiring harness between steering angle sensor terminal H and ground point, then repair or replace if necessary.

5.  Turn the ignition switch to the LOCK position.

6.  Connect the M-MDS to the DLC-2.

amxzzw00000129

7.  Select the “SWA_POS” PID.

8.  Verify the SWA_POS changes when the steering wheel is turned to the left and right.

•  If there is any malfunction, replace the steering angle sensor.