DATA MONITORING AND RECORDING PROCEDURE

id092200801500

1. Connect the M-MDS to the DLC-2.

amxzzw00001706

2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

• When using the IDS (laptop PC)

― Select “DataLogger”.

― Select “Modules”.

― Select “IC”.

• When using the PDS (Pocket PC)

― Select “Module Tests”.

― Select “IC”.

― Select “DataLogger”.

3. Select the applicable PID from the PID table.

4. Verify the PID data according to the directions on the screen.

Note

• The PID data screen function is used for monitoring the calculated value. Therefore, if the monitored value of the output parts is not within the specification, inspection of the monitored value of input parts corresponding to applicable output part control is necessary. In addition, because the system does not display output part malfunction as abnormality in the monitored value, it is necessary to inspect the output part individually.

Indication Item Table

Monitor item

Input-output signal/part name

Unit/State

Terminal

IC_DTC_CNT

Number of continuous DTCs

—

—

IC_ECT

Water temperature gauge

°C

1J, 1L

IC_NUMKEYS

Number of key ID numbers registered with the vehicle

—

—

IC_ODO_CNT

Odometer

m

1J, 1L

IC_SPDMTR

Speedometer

KPH

IC_TACHO

Tachometer

RPM

IC_VPWR

Power supply voltage

V

1C

Monitor item	Input-output signal/part name	Unit/State	Terminal
IC_DTC_CNT	Number of continuous DTCs	—	—
IC_ECT	Water temperature gauge	°C	1J, 1L
IC_NUMKEYS	Number of key ID numbers registered with the vehicle	—	—
IC_ODO_CNT	Odometer	m	1J, 1L
IC_SPDMTR	Speedometer	KPH
IC_TACHO	Tachometer	RPM
IC_VPWR	Power supply voltage	V	1C