MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR INSPECTION [MZ-CD 1.4 DI Turbo]

id0140b8800900

Caution

•  Water penetrating the connector will cause sensor malfunction. To prevent this, be careful not to damage the wiring harnesses or the waterproof connector so as to cause water penetration.

Visual Inspection

1.  Remove the MAP sensor. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION [MZ-CD 1.4 DI Turbo].)

2.  Verify that there are no metal shavings on the sensor.

3.  Visually inspect the MAP sensor for the following:

•  Damage

•  Cracks

•  Rusted sensor terminal

•  Bent sensor terminal

―  If there is any malfunction, replace the MAP sensor. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION [MZ-CD 1.4 DI Turbo].)

4.  Install the MAP sensor. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION [MZ-CD 1.4 DI Turbo].)

Voltage Inspection

1.  Turn the ignition switch to the ON position (Engine off).

2.  Measure the voltage between MAP sensor terminal A and body ground.

am2zzw00002920

•  If it is not as specified, replace the MAP sensor. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION [MZ-CD 1.4 DI Turbo].)

3.  Start the engine.

4.  Measure the voltage between MAP sensor terminal A and body ground when applying boost.

am2zzw00002920

•  If it is not as specified, replace the MAP sensor. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION [MZ-CD 1.4 DI Turbo].)

5.  Stop the engine.

6.  Remove the MAP sensor, then connect the MAP sensor connector to the MAP sensor.

7.  Connect the vacuum pump to the MAP sensor.

8.  Turn the ignition switch to the ON position (Engine off).

9.  Measure the voltage between MAP sensor terminal A and body ground when applying vacuum.

•  If it is not as specified, replace the MAP sensor. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION [MZ-CD 1.4 DI Turbo].)