WINDSHIELD WIPER ARM AND BLADE REMOVAL/INSTALLATION

id091900474600

Warning

•  When the ignition switch is turned to the ON position, and the wiper and washer switch is in the AUTO position, the windshield wipers could operate accidentally under the following conditions. Always turn the ignition switch, and the wiper and washer switch off before handling the windshield wipers; otherwise a pinched hand or fingers could result in injury or a wiper system malfunction:

―  The windshield in the rain sensor installation area is touched.

―  The windshield is subjected to an impact.

―  The rain sensor is subjected to an impact from inside the vehicle.

―  Water is poured on the windshield.

1.  Remove in the order indicated in the table.

L.H.D.

am2zzw00005065

R.H.D.

am2zzw00005066

1	Cap
2	Nut
3	Windshield wiper arm (See: Windshield Wiper Arm Installation Note.)
4	Windshield wiper blade
5	Backing plate
6	Rubber brush

2.  Install in the reverse order of removal.

3.  Adjust the windshield wiper arm and blade. (See WINDSHIELD WIPER ARM AND BLADE ADJUSTMENT.)

Windshield Wiper Arm Installation Note

1.  Clean the serrated connecting part with a wire brush before installing the windshield wiper arm.

am2zzw00002122