THROTTLE POSITION (TP) SENSOR INSPECTION [ZY]

Caution

• This inspection procedure cannot be completed correctly if the APP sensor has a malfunction. Before performing this procedure, verify that any one of the DTCs related to the APP sensor is not detected.

Note

• Before performing the following inspection, make sure to follow the troubleshooting flowchart.

Voltage Inspection

1. Turn the ignition switch to the ON position.

2. Verify that the TP sensor output voltage (WDS PID: TP1, TP2) is within the specification. (See PCM INSPECTION [ZY].)

• If not within the specification, replace the throttle body. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [ZY].)

• If the monitor item condition/specification (reference) is not within the specification, even though there is no malfunction, perform the "Circuit Open/Short Inspection".

Circuit Open/Short Inspection

1. Remove the PCM connector cover.

2. Disconnect the PCM connector. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [ZY].)

3. Disconnect the throttle body connector.

4. Inspect the following wiring harnesses for open or short circuit. (Continuity inspection)

Open circuit

• If there is no continuity in the following wiring harnesses, there is an open circuit. Repair or replace the wiring harness.

- Throttle body terminal C and PCM terminal 2AW

- Throttle body terminal D and PCM terminal 2AT

- Throttle body terminal E and PCM terminal 2AS

- Throttle body terminal F and PCM terminal 2AX

Short circuit

• If there is continuity in the following wiring harnesses, there is a short circuit. Repair or replace the wiring harness.

- Throttle body terminal C and body ground

- Throttle body terminal C and power supply

- Throttle body terminal E and body ground

- Throttle body terminal E and power supply

- Throttle body terminal F and body ground

- Throttle body terminal F and power supply

- Throttle body terminal D and body ground

- Throttle body terminal D and power supply