|
DTC No.
|
On-board diagnostic function
|
Detection condition
|
Fail-safe
|
TCC
|
|
P0706
|
Transaxle range (TR) switch circuit range/performance
|
• No TR signal (P, R, N, D, S or L range/position) input to PCM terminal 1AS when the engine speed is 530 rpm or more, vehicle speed is 20 km/h {12 mph} or more and voltage at PCM terminal 1AS is 0.5 V or more.
|
• Inhibits gear shifting and maximizes line pressure
|
Disabled
|
|
P0707
|
Transaxle range (TR) switch circuit low input
|
• Input voltage from the TR switch to PCM terminal 1AS is 0.5 V or less when the engine speed is 530 rpm or more and vehicle speed is 20 km/h {12 mph} or more.
|
• Inhibits gear shifting and maximizes line pressure
|
Disabled
|
|
P0708
|
Transaxle range (TR) switch circuit high input
|
• Input voltage from the TR switch to PCM terminal 1AS is 4.79 V or more when the engine speed is 530 rpm or more and vehicle speed is 20 km/h {12 mph} or more.
|
• Inhibits gear shifting and maximizes line pressure
|
Disabled
|
|
P0711
|
Transaxle fluid temperature (TFT) sensor circuit range/performance (Stuck)
|
• Input voltage from the TFT sensor to PCM terminal 1AH and 1AG is maintained at 0.03 V or less when 180 s have passed after the engine is started and the vehicle is driven for 90 s or more at vehicle speed between 25-59 km/h {15-36 mph}, and then 60 km/h {37 mph} or more for 60 s or more.
|
N/A
|
Disabled
|
|
P0712
|
Transaxle fluid temperature (TFT) sensor circuit malfunction (short to ground)
|
• Input voltage from the TFT sensor to PCM terminal 1AH and 1AG is maintained at 0.06 V or less when the vehicle speed is 20 km/h {12 mph} or more.
|
• Sets temperature to cold condition and maximizes line pressure
|
Disabled
|
|
P0713
|
Transaxle fluid temperature (TFT) sensor circuit malfunction (open circuit)
|
• Input voltage from the TFT sensor to PCM terminal 1AH and 1AG is maintained at 4.67 V or more when vehicle speed is 20 km/h {12 mph} or more.
|
• Sets temperature to cold condition
|
Disabled
|
|
P0715
|
Input/turbine speed sensor circuit malfunction
|
• No input/turbine speed sensor signal to PCM terminals 1R and 1V when the vehicle speed is 41 km/h {25 mph} or more and selector lever position is at D, S, L or M range.
|
• Inhibits 4GR
|
Disabled
|
|
P0720
|
Vehicle speed sensor (VSS) circuit malfunction
|
• No VSS signal is input to PCM terminal 1AX when and engine coolant temperature is 60 °C {140 °F} or more, input/turbine speed sensor signal is 1,500 rpm or more and selector lever position is at D, S, L or M range.
|
• Vehicle speed signal calculated from input/turbine speed sensor
|
Enabled
|
|
P0731
|
Gear 1 incorrect (incorrect gear ratio detected)
|
• Revolution ratio of the forward clutch drum to differential gear case revolution is 2.185 or less while in 1GR.
|
• Inhibits 1GR and maximizes line pressure
|
Enabled
|
|
P0732
|
Gear 2 incorrect (incorrect gear ratio detected)
|
• Revolution ratio of the forward clutch drum to differential gear case revolution is 1.277 or less or 2.185 or more while in 2GR.
|
• Inhibits 2GR and maximizes line pressure
|
Enabled
|
|
P0733
|
Gear 3 incorrect (incorrect gear ratio detected)
|
• Revolution ratio of the forward clutch drum to differential gear case revolution is 0.848 or less or 2.185 or more while in 3GR.
• Revolution ratio of the forward clutch drum to differential gear case revolution is within 1.404-1.704 while in 3GR (TCC no operating).
|
N/A
|
Enabled
|
|
P0734
|
Gear 4 incorrect (incorrect gear ratio detected)
|
• Revolution ratio of the forward clutch drum to differential gear case revolution is 0.57 or less or 1.277 or more while in 4GR.
• Revolution ratio of the forward clutch drum to differential gear case revolution is within 0.91-1.09 while in 4GR (TCC no operating).
|
• Inhibits 4GR and maximizes line pressure
|
Enabled
|
|
P0741
|
Torque converter clutch (TCC) (stuck off)
|
• Difference between the engine speed and turbine speed is more than 100 rpm while TCC is operating.
|
• Inhibits TCC and maximizes line pressure
|
Disabled
|
|
P0742
|
Torque converter clutch (TCC) (stuck on)
|
• Difference between the engine speed and turbine speed is 50 rpm or less while TCC is not operating.
|
• Inhibits TCC and maximizes line pressure
|
Disabled
|
|
P0745
|
Pressure control solenoid malfunction
|
• Voltage is stuck at 0 V or B+ at pressure control solenoid control terminal 1P of the PCM when the solenoid valve operates according to PCM calculation.
|
N/A
|
Enabled
|
|
P0751
|
Shift solenoid A stuck off
|
• Revolution ratio of the forward clutch drum to differential gear case revolution is within 0.91-1.09 in 4GR and DTCs not output
|
• Inhibits 4GR and TCC and maximizes line pressure
|
Disabled
|
|
P0752
|
Shift solenoid A stuck on
|
• Input/turbine speed sensor signal is 187.5 rpm or more in D range
|
• Inhibits 1GR, 2GR, and 3GR and maximizes line pressure
|
Enabled
|
|
P0753
|
Shift solenoid A malfunction (electrical)
|
• Voltage is stuck at 0 V or B+ at shift solenoid A control terminal 1D of the PCM when the solenoid valve operates according to PCM calculation.
|
• Inhibits 4GR and TCC and maximizes line pressure
|
Disabled
|
|
P0756
|
Shift solenoid B stuck off
|
• Revolution ratio of the forward clutch drum to differential gear case revolution is 2.185 or less in 1GR and DTCs not output.
|
• Inhibits 1GR and 4GR and maximizes line pressure
|
Enabled
|
|
P0757
|
Shift solenoid B stuck on
|
• Revolution ratio of the forward clutch drum to differential gear case revolution is 1.277 or less or 2.185 or more in D range 2GR.
• Revolution ratio of the forward clutch drum to differential gear case revolution is 0.57 or less or 1.277 or more in D range 4GR.
|
• Inhibits 2GR and 4GR and maximized line pressure
|
Enabled
|
|
P0758
|
Shift solenoid B malfunction (electrical)
|
• Voltage is stuck at 0 V or B+ at shift solenoid B control terminal 1H of the PCM when the solenoid valve operates according to PCM calculation.
|
• Inhibits 1GR and 4GR and maximizes line pressure
|
Enabled
|
|
P0761
|
Shift solenoid C stuck off
|
• Revolution ratio of the forward clutch drum to differential gear case revolution is 2.185 or less in D range 1GR.
• Revolution ratio of the forward clutch drum to differential gear case revolution is 1.277 or less or 2.185 or more in D range 2GR.
|
• Inhibits 1GR and 2GR and maximizes line pressure
|
Enabled
|
|
P0762
|
Shift solenoid C stuck on
|
• Revolution ratio of the forward clutch drum to differential gear case revolution is within 1.404-1.704 in D range 3GR.
|
• Inhibits 3GR and 4GR and maximizes line pressure
|
Enabled
|
|
P0763
|
Shift solenoid C malfunction (electrical)
|
• Voltage is stuck at 0 V or B+ at shift solenoid C control terminal 1L of the PCM when the solenoid valve operates according to PCM calculation.
|
• Inhibits 1GR and 2GR and maximizes line pressure
|
Enabled
|
|
P0766
|
Shift solenoid D stuck off
|
• Revolution ratio of the forward clutch drum to differential gear case revolution is 0.57 or less or 1.277 or more in D range 4GR.
|
• Inhibits 4GR and maximizes line pressure
|
Enabled
|
|
P0767
|
Shift solenoid D stuck on
|
• Revolution ratio of the forward clutch drum to differential gear case revolution is 0.848 or less or 2.185 or more in D range 3GR.
|
• Inhibits 2GR, 4GR, and TCC and maximizes line pressure
|
Disabled
|
|
P0768
|
Shift solenoid D malfunction (electrical)
|
• Voltage is stuck at 0 V or B+ at shift solenoid D valve control terminal 1K of the PCM when the solenoid valve operates according to PCM calculation.
|
• Inhibits 4GR and maximizes line pressure
|
Enabled
|
|
P0771
|
Shift solenoid E stuck off
|
• Difference between engine speed and turbine speed is more than 100 rpm while driving in 4GR is at D range during TCC operation.
|
• Inhibits TCC and maximized line pressure
|
Disabled
|
|
P0772
|
Shift solenoid E stuck on
|
• Difference between the engine speed and turbine speed is 50 rpm or less while driving in 4GR at D range while TCC is not operating.
|
• Inhibits 1GR and maximizes line pressure
|
Enabled
|
|
P0773
|
Shift solenoid E malfunction (electrical)
|
• Voltage is stuck at 0 V or B+ at shift solenoid E control terminal 1O of the PCM when the solenoid valve operates according to PCM calculation.
|
• Inhibits TCC and maximized line pressure
|
Disabled
|
|
P0894
|
Forward clutch torque transmission
|
• Turbine speed does not fall to less than 187 rpm 3 s or more after starting the engine with the vehicle stopped (brake applied) and the selector lever shifted to D range from N position.
|
• Driving restricted to 4GR
|
Enabled
|