DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION
id081000801300
-
Warning
-
• Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the service warnings and cautions before handling the air bag module.
-
(See SERVICE WARNINGS.) (See SERVICE CAUTIONS.)
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove in the order indicated in the table.
1
|
Bolt
|
2
|
Connector
|
3
|
Driver-side air bag module
|
4. Install in the reverse order of removal.
5. Turn the ignition switch to the ON position.
6. Verify that the air bag system warning light illuminates for approx. 3 s and goes out.
-
• If the air bag system warning light does not operate, refer to the on-board diagnostic system (air bag system) and perform inspection of the system.