NO.11 MD PLAYER DOES NOT LOAD THE MD OR EJECTS THE MD IMMEDIATELY


11	MD player does not load the MD or ejects the MD immediately Possible DTC: 07:Er01
Troubleshooting hints • MD malfunction • MD panel malfunction • MD panel improperly installation • MD player malfunction • Poor connection of MD player connector or terminal (e.g., damaged, bent, pulled-out pin, corrosion) • Non-conventional MD (Hi-MD) Note • The Hi-MD has longer recording time and higher sound quality than the conventional MD. The conventional MD can be formatted to Hi-MD, but it can be played on the Hi-MD player only.


STEP	INSPECTION		ACTION
1	• Visually inspect the MD. • Is there any dirt, scratch or deformation on the MD?	Yes	Explain to the customer that the defective MD cannot be used.
1		No	Go to the next step.
2	• Is there Hi-MD?	Yes	Explain to the customer that the Hi-MD cannot be used.
2	• Is there Hi-MD?	No	Go to the next step.
3	• Visually inspect the MD panel. • Is there any damage on the MD panel?	Yes	Replace the MD panel.
3		No	Go to the next step.
4	• Visually inspect the MD panel installation condition. • Is the MD panel installation properly?	Yes	Re-install the MD panel properly.
4		No	Go to the next step.
5	• Turn the ignition switch to the LOCK position. • Inspect the MD player connector. • Inspect both MD player connector and wiring harness-side connector for poor connection (such as damaged/bent/pulled-out pins, corrosion) • Are all the pins and connector normal?	Yes	Troubleshooting is completed.
5		No	If the MD player connector/pin is malfunctioning: • Replace the MD player. If the wiring harness-side connector/pin is malfunctioning: • Repair or replace the pins and/or connector.