AUTO LEVELING SENSOR INSPECTION

id091800805600

1.  Connect the three dry cell batteries (1.5 V) in series.

am2zzw00007223

2.  Connect the positive pole of the battery to auto leveling sensor terminal A, and the negative pole to terminal C, then apply voltage of 4.5 V between terminals A and C.

3.  Connect the tester as shown in the figure.

4.  Measure the voltage while the link is moved up and down slowly.

•  If not as indicated in the table, replace the auto leveling sensor.

Link angle (vehicle height)	Voltage (V)
+45° (High)	Approx. 4.1
0°	2.25
-45° (Low)	Approx. 0.5