CAMSHAFT INSPECTION

id011000501500

1. Set the No.1 and No.5 journals of the camshaft on V-blocks.

b3e0110e074

2. Measure the camshaft runout using a dial gauge.

• If it exceeds the maximum specification, replace the camshaft.

Maximum runout

0.03 mm {0.001 in}

3. Measure the cam lobe height as shown using the micrometer.

b3e0110e076

• If it is less than the minimum specification, replace the camshaft.

Standard cam lobe height (mm {in})

Camshaft	ZJ	ZY, Z6
IN	41.373 {1.6289}
EX	40.597 {1.5983}	41.495 {1.6337}

Minimum cam lobe height (mm {in})

Camshaft	ZJ	ZY, Z6
IN	41.30 {1.6260}
EX	40.53 {1.5957}	41.43 {1.6311}

4. Measure the journal diameter using the micrometer. Measurement positions total four, and they are in the X and Y directions, at the two points (A and B) as shown in the figure.

b3e0110e032

• If it is less than the minimum specification, replace the camshaft.

Standard journal diameter

25.950—25.975 mm {1.022—1.023 in}

Minimum journal diameter

24.910 mm {0.9807 in}

5. Measure the camshaft journal oil clearance using a plastigauge with the tappet removed.

b3e0110e077

Note

• Clean the camshaft journal and the journal receptacle part.

• Cut the plastigauge to the same length as the journal width and position it in parallel to the camshaft.

• If it exceeds the specification, replace the cylinder head.

Standard oil clearance

0.034—0.080 mm {0.0014—0.0031 in}

Maximum oil clearance

0.09 mm {0.0035 in}

6. Measure the camshaft end play using a dial gauge.

adj2224e190

• If it exceeds the maximum specification, replace the cylinder head or the camshaft.

Standard end play

0.07—0.19 mm {0.0027—0.0074 in}

Maximum end play

0.20 mm {0.0078 in}