QUICK RELEASE CONNECTOR (EMISSION SYSTEM) REMOVAL/INSTALLATION [ZJ, ZY]


id0116b7805500


Quick Release Connector Type

Caution
•  There are two types of quick release connectors. Verify the type and location, and install/remove properly.
am2zzw00001580

Type A Removal

1.  Release the retainer shown in the figure.

am2zzw00001581

2.  Disconnect the quick release connector.

3.  Cover the disconnected quick release connector and fuel pipe with vinyl sheeting or a similar material to prevent it from scratches or dirt.


Type B Removal

1.  Release the retainer shown in the figure.

am2zzw00001582

2.  Disconnect the quick release connector.

3.  Cover the disconnected quick release connector and fuel pipe with vinyl sheeting or a similar material to prevent it from scratches or dirt.


Type A Installation

1.  Inspect the fuel hose and fuel pipe sealing surface for damage and deformation.

•  If there is any malfunction, replace it with a new one.

2.  Install the quick release connector.

adejjw00002454

3.  Lightly pull and push the quick release connector a few times by hand, and then verify that it is connected securely.


Type B Installation

1.  Inspect the fuel hose and fuel pipe sealing surface for damage and deformation.

•  If there is any malfunction, replace it with a new one.

2.  Install the quick release connector.

adejjw00002455

3.  Lightly pull and push the quick release connector a few times by hand, and then verify that it is connected securely.