FUEL INJECTOR CALIBRATION CODE PROGRAM [MZ-CD 1.6 (Y6)]

id0140b2807300

Note

•  Regarding the Injector Calibration Code, if the PCM is newly replaced, the PCM records a DTC (P1675:00 and P1676:00) and illuminates the malfunction indicator lamp even if there is no malfunction. Therefore, if the PCM or fuel injector is replaced, program the injector calibration code in the PCM using the following procedure.

•  Cylinder 1 and fuel injector 1 are located at the end of the transaxle.

am3zzw00001122

•  Use the IDS (laptop PC) because the PDS (Pocket PC) does not support the FUEL INJECTOR CALIBRATION PROGRAM

1.  Connect the M-MDS to DLC-2.

am2zzw00004050

2.  After the vehicle is identified, select the following items from the initial screen of the M-MDS.

When using the IDS (laptop PC)

1.  Select the “Powertrain”.

3.  Then, select items from the screen menu in the following order.

1.  Select “Service Functions”.

2.  Select “PCM”.

4.  Select “Fuel Injector Correction Factors” and perform procedures according to directions on the M-MDS screen.

5.  Retrieve DTCs by the M-MDS, then verify that there is no DTC present.

•  If a DTC(s) is detected, perform the applicable DTC inspection.