DSC SENSOR INITIALIZATION PROCEDURE
id041500870000
-
Warning
-
• If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the combined sensor or DSC HU/CM, make sure to perform the initialization procedure to insure proper DSC operation.
1. Inspect the wheel alignment and the inflation pressure.
-
• If there is any malfunction, adjust the applicable part.
2. Park the vehicle on level ground.
3. Turn the ignition switch to the LOCK position.
4. Connect the M-MDS to DLC-2.
5. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
-
• When using the IDS (laptop PC)
-
1. Select “Chassis”.
2. Select “ABS/DSC”.
3. Select “Sensor Initialization”.
• When using the PDS (Pocket PC)
-
1. Select “All Tests and Calibrations”.
2. Select “Sensor Initialization”.
6. Then, select items from the screen menu in the following order.
-
• Brake Fluid Pressure Sensor
• Lateral Acceleration Sensor
7. Perform the initialization procedure according to the directions on the screen.