DTC U3003:1C

id080200823400

System Malfunction Location

• SAS control module circuit voltage value out of range

Detection Condition

Warning

• Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.

• SAS control module circuit power supply voltage is 18 V or more

Possible Causes

• Battery over-charge

• SAS control module malfunction

Diagnostic Procedure

Step

Inspection

Action

1

PERFORM PCM DTC INSPECTION

•  Perform the PCM DTC inspection using the M-MDS.
(See ON-BOARD DIAGNOSTIC TEST [ZJ, ZY].)

(See ON-BOARD DIAGNOSTIC TEST [MZ-CD 1.4 DI Turbo].)

•  Is DTC P2504:00 displayed?

Yes

Perform a separate inspection of the applicable DTCs.

(See DTC TABLE [ZJ, ZY].)

(See DTC TABLE [MZ-CD 1.4 DI Turbo].)

No

Go to the next step.

2

PERFORM SAS CONTROL MODULE DTC INSPECTION

•  Clear the DTC for the SAS control module using the M-MDS.
(See CLEARING DTC.)

•  Perform the DTC inspection for the SAS control module using the M-MDS.
(See DTC DISPLAY.)

•  Are the same DTCs present?

Yes

Replace the SAS control module.

(See SAS CONTROL MODULE REMOVAL/INSTALLATION.)

No

DTC troubleshooting completed.

Step	Inspection		Action
1	PERFORM PCM DTC INSPECTION • Perform the PCM DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [ZJ, ZY].) (See ON-BOARD DIAGNOSTIC TEST [MZ-CD 1.4 DI Turbo].) • Is DTC P2504:00 displayed?	Yes	Perform a separate inspection of the applicable DTCs. (See DTC TABLE [ZJ, ZY].) (See DTC TABLE [MZ-CD 1.4 DI Turbo].)
1		No	Go to the next step.
2	PERFORM SAS CONTROL MODULE DTC INSPECTION • Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC.) • Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC DISPLAY.) • Are the same DTCs present?	Yes	Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION.)
2		No	DTC troubleshooting completed.