BUMPER REINFORCEMENT REMOVAL/INSTALLATION


id091000405700

Caution
•  Because the shroud panel is installed to the bumper reinforcement, support the shroud panel using a jack before removing the bumper reinforcement so as not to apply excessive force to the shroud panel.
•  Since the servicing is performed with the bonnet open, secure the bonnet using a piece of wood to prevent it from falling.

1.  Disconnect the negative battery cable.

2.  Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION)

3.  Remove the front combination light. (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION)

4.  Remove the horn. (See HORN REMOVAL/INSTALLATION)

5.  Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)

6.  Remove bolt A.

am2zzw00003466

7.  Remove bolts B.

am2zzw00003467

8.  Remove bolts C and D then remove the bumper reinforcement in the direction of the arrow shown in the figure.

am2zzw00003441

9.  Remove the bracket in the direction shown of the arrow shown in the figure.

am2zzw00003468

10.  Install in the reverse order of removal.