POWER WINDOW MOTOR INSPECTION

id091200417000


Driver's Side

1.  Disconnect the negative battery cable.

2.  Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION.)

3.  Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION.)

4.  Disconnect the power window motor connector.

5.  Apply battery positive voltage and connect the ground to power window motor terminals E and F, and then inspect the power window motor operation.

am2zzw00003826

•  If the power window motor does not operate as indicated in the table, replace it.

Operation

Terminal

E

F
Open
Ground
B+
Close
B+
Ground

6.  Connect the battery positive voltage to power window motor terminal D and connect terminal C to ground.

7.  Operate the power window motor and measure the voltage at terminals A and B.

•  If there is any malfunction, replace the power window motor.
Voltage
Pulse: max. 5 V/min. 0 V


Except Driver's Side

1.  Disconnect the negative battery cable.

2.  Remove the inner garnish.(Front side) (See INNER GARNISH REMOVAL/INSTALLATION.)

3.  Remove the front door trim.(Front side) (See FRONT DOOR TRIM REMOVAL/INSTALLATION.)

4.  Remove the sail inner garnish (Rear side) (See SAIL INNER GARNISH REMOVAL/INSTALLATION.)

5.  Remove the Rear door trim (Rear side) (See REAR DOOR TRIM REMOVAL/INSTALLATION.)

6.  Disconnect the power window motor connector.

7.  Apply battery positive voltage and connect the ground to the power window motor terminals, and then inspect the power window motor operation.

am2zzw00003827

•  If the power window motor does not operate as indicated in the table, replace it.

Operation

Terminal

E

F
Open
Ground
B+
Close
B+
Ground